diff --git a/target/product/angle_default.mk b/target/product/angle_default.mk
new file mode 100644
index 0000000000..bea0be6d53
--- /dev/null
+++ b/target/product/angle_default.mk
@@ -0,0 +1,23 @@
+#
+# Copyright 2023 The Android Open-Source Project
+#
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+#      http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+#
+
+# To enable ANGLE as the default system GLES drivers, add
+# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle_enabled.mk) to the Makefile.
+
+$(call inherit-product, $(SRC_TARGET_DIR)/product/angle_supported.mk)
+
+PRODUCT_VENDOR_PROPERTIES += \
+    persist.graphics.egl=angle
diff --git a/target/product/angle.mk b/target/product/angle_supported.mk
similarity index 71%
rename from target/product/angle.mk
rename to target/product/angle_supported.mk
index 0d7f8cb1c0..c83ff5fcb2 100644
--- a/target/product/angle.mk
+++ b/target/product/angle_supported.mk
@@ -14,13 +14,14 @@
 # limitations under the License.
 #
 
-# To include ANGLE drivers into the build, add
-# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle.mk) to the Makefile.
+# To include ANGLE into the image build, add
+# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle_supported.mk) to the Makefile.
+# By default, this will allow ANGLE binaries to coexist with native GLES drivers.
 
-PRODUCT_PACKAGES := \
+PRODUCT_PACKAGES += \
     libEGL_angle \
     libGLESv1_CM_angle \
     libGLESv2_angle
 
 # Set ro.gfx.angle.supported based on if ANGLE is installed in vendor partition
-PRODUCT_VENDOR_PROPERTIES := ro.gfx.angle.supported=true
+PRODUCT_VENDOR_PROPERTIES += ro.gfx.angle.supported=true